What if the prompt “you have dialed wrong number” comes even after dialing a valid number over CO?

From Matrix Wiki
Jump to: navigation,
  • Check if the same problem is observed by directly terminating the CO line over an analog phone.
  • If the problem is not observed follow below given steps.

Step 1: Go to CO configuration > CO hardware templates > Pause timer (m sec).

Step 2: Change the value of pause timer in CO hardware template one by one to all available options such as 500, 1000, 1500, 2000, and 2500.

Step 3: If the problem persists, increase the speech delay timer to 001 sec and check with all the pause timer options again.